E-MetroTel UCX50 Quick Start Manual - page 3
www.emetrotel.com
Page 2
copyright © 2011 E-Metrotel Global Inc
1.
2.
3.
4.
5.
6.
7.
1.
2.2. Removing the Hard Drive
If your BCM uses
, remove two screws that attach the bracket to the bottom of the case.
the newer hard disk bracket
Remove fan wires from the clip(s) on the back of the hard disk bracket.
Disengage the power connector latch gently with a flat screwdriver and disconnect the hard disk power cable from the main board.
Press the latch on the red SATA data cable and disconnect the cable from the main board.
Lift the hard disk bracket from the case and place it on a static-free surface.
Remove four screws that secure the hard drive to the bracket and remove the hard drive from the bracket.
Remove the power cable and the SATA data cable (or the combined SATA power and data cable) from the hard disk connectors.
2.3. Inserting the Solid State Drive
If you have the older style BCM hard disk bracket (one where the hard drive was mounted from the bottom of the bracket), you must use
the SSD 2.5” to 3.5” conversion bracket that is included with the SSD.