Eacome G2S Series User Manual - page 7
10
11
#
Press key to cancel the call in the process of dialling.
USB LINE(Available for U)
U model is able to connect to PC and video
conferencing system via USB, providing up to 16 KHz
bandwidth for speaker and microphones.Make sure
the PC/video devices are ready when placing a call
through USB line.
For these instructions, it is assumed that the
computer is turned on,the VoIP software (e.g.Skype)
or video conferencing software is running and the
G2S is connected to the computer via the USB cable.
1. USB marked on the left side of the phone
console is used to connect to the USB port of
PC or video teleconferencing by USB cable.
It will take 5-10 seconds to install the driver
automatically for the first setup.
2. Press key to open G2S speaker and
microphones to enjoy the HD-voice USB VoIP
conversation. The blue indicator LEDs always
keep on. The LCD screen will display “USB“.
3. Press in the call state to exit this USB VoIP
call.
USINg YOUR PHONE
Placing a Call
G2S allows you to place a call over an analog phone line.Available for P model.
G2S allows you to place a call over a USB line.Available for U model.
PSTN Line(Direct Dial,Redial,Rapid Dial, Recall)
1. Direct
Dial
To obtain dial tone, press key.Then dial the desired number.
The blue indicator LEDs always keep on.
2. Redial
Press the “REDIAL” key.The last number called will be displayed and dialled.
3. Rapid
Dial
In stand-by,press rapid-dial "MEMO" key,the LCD will display”SPDL[01-20]”
Then dial two rapid-dial slot identification number.
4. Recall
In stand-by, use the volume buttons to look through previously dialled
numbers,press “REDIAL”key to dial the numbers you select.
#
When a call is coming,press key then G2S will turn on speaker and microphones.
When you press key in stand-by, G2S will turn on microphones only after you
press any number key.
#
The blue indicator LEDs always keep on and the LCD will display “PSTN”.
Answering a Call
The indicator LEDs will blink red when the phone
rings.
Press to answer an incoming call from analog
phone line. The LCD will display “PSTN”.
Call Mute
To mute a call, press the "MUTE" button during a
call to turn the microphone off.
The red LEDs will keep on.
#
To release mute, press the mute button again.
Call hold
To place a call on hold, press the ”HOLD” key. Both
the microphones and the speaker are turned off.
The blue LEDs will keep on.
Redial
Press the “REDIAL” key. The last number called will
be displayed and dialled.
Recall
In stand-by, use the volume buttons to look
through previously dialled numbers,press “REDIAL”
key to dial the numbers you select.
Ending a Call
To end a PSTN/USB call in the call state, press the
key.
Searching For an Entry
1. Press
key, the LCD will display dialled numbers for latest 20 entries.
2. Press
key, the LCD will display incoming numbers for latest 20 entries.
BLUE
RED
6
7
8
9
10
11