Eacome G2S Series User Manual - page 9
14
15
Function Adjustment
1. Set the Date/Time:
Press key and then the screen display 1 SET DATE. Then press the key to
confirm and select the setting item. When the item font is flashing , press the
key to set, press “MUTE” key to confirm.
2. Set Flash: Flash Time90/100/120/180/300/500/600/900ms
Press key and then press till the screen display 2 SET FALSH. Then press
key to enter the situation of setting. Press to choose the wanted standard of
flash. At last, press the key to confirm.
3. Adjust the LCD Bright:
Press key and then press till the screen display 3 SET BRIGHT. Then press
to enter the situation of the setting, adjust the bright of LCD through operating
, at last, press to confirm.
4. Store and Rapid Dial(Store 20 group of Speed-dial Numbers)
Press and then press till the screen display 4 SPEEDIAL. Then press to
confirm and select the setting item.The LCD will display “GROUP[01-20]”. Then
input the double-digit serial number of speed-dial from 01 to 20, then input the
corresponding
phone
number.
If you want to cover or re-edit the existed number,press , the LCD will display
“BEGIN CANCEL“, choose ”BEGIN”, then press to input a new phone number.
If you don’t want to cover or re-edit the existed number, choose “CANCEL”, then
press .
Speaker Volume Adjustment
1. During an active call, press the volume buttons to adjust the speaker volume.The
speaker volume will increase from 1 to 12.The volume level will display on the LCD
screen.The current main volume appears on the display screen.
2. The LEDs will blink green within the scope and will blink red beyond the scope
when adjusting the volume.
Special settings:
G2S provides “PA” and “0” settings for PA system applications.
G2S will turn off the internal microphones and local speaker when the volume level
is “PA” setting.
G2S will turn off local speaker when the volume level is “0” setting.
PSTN Flash Setting and Access
1. To access PSTN Flash Setting, press , and use Selection Keys to select Flash. Press
.
2. The LCD will show flash time type,then select the type you want.
3. Press “FLASH” button to perform FLASH function.(G2S-P Model Series).
#
By default, Flash time is set to 300ms.
Do Not Disturb(DND)
In stand-by,long press the “FLASH” button for 5 seconds to enter the DND status. The
LCD will display "DND".When you have an incoming call,the red indicator LEDs will
blink and you cannot hear ringing tone.
#
The green indicator LEDs will blink when setting DND.
Cancelling the DND
Long press the FLASH button for 5 seconds, the green indicator LEDs will blink
and"DND" on the LCD will disappear.
#
After power failure, the setting will restore to default.