Eagle Alarm Verification Products 2244 Installation instructions manual - page 10
10
TABLE 6: STATUS LED INDICATOR.
# FLASHES EVERY SIX SECONDS
MODE
1 (
ONE
)
S
TANDBY OPERATION
-
ALL
OK
2 (
TWO
) O
NE RING CALL BACK MODE
,
WAITING FOR RING
3 (
THREE
)
C
ALL HAS BEEN ANSWERED
,
WAITING FOR ACKNOWLEDGMENT CODE
.
4 (
FOUR
) E
MERGENCY PHONE HAS COMPLETED CALL
,
WAITING FOR CS OPERATOR
TO PRESS
DTMF
DIGIT
.
STEADY ILLUMINATION
T
WO
W
AY ACTIVE
.
4.4 CENTRAL STATION DETECTION.
The 2244 features central station detection with auto-disconnect. This feature allows the module to detect if the central station
receiver operator failed to send a shut down command. The 2244 will automatically shut down (within 15 seconds) of the
operator hanging up.
5.0 PROGRAMMING THE MODULE.
5.1 OPTION DESCRIPTION.
______________________________________________________________________
Option 1: Voice Message Bypass
This is also known as the ring-pause ring mode. This option selects the number of rings for the first “ring” before
hanging up and calling back. The unit will always answer on the first ring subsequent to hanging up after the required
number of rings, provided the option is enabled.
Note: You must wait at least 10 seconds, but no longer than 60 seconds, when making the second call.
1 – 9
=
Selects Bypass. The number entered selects the number of rings required before hanging up.
0 =
Option
disabled.
DEFAULT =
0
______________________________________________________________________
Option 2: Full Time Call Back
This option determines the number of rings the 2244 will answer when in the call back mode.
1 – 9
=
Selects full time callback active. The number entered selects the number of rings before the 2244 answers.
0 =
Option
disabled.
DEFAULT =
1
______________________________________________________________________
Option 3: Call – In or Alarm Call Acknowledge Code
This option determines which sequence of Touch Tone digits will acknowledge the TERMINATOR
in the call - in
mode or after an alarm activation and call to the central station.
1 =
Single
*
will access
2
=
Custom code (User Code only) will access
DEFAULT =
1
______________________________________________________________________
Option 4: No Activity Time
This option selects how much time must pass before the 2244 hangs up when no DTMF digits are sent from the
central station.
0 – 9
=
Enter the time, in minutes.
0
= Option
disabled.
DEFAULT =
5
______________________________________________________________________
Option 5: Phone number transmission delay
This option selects the amount time the 2244 waits for the video equipment to send the telephone number to dial. If
the time elapses before a number is received the 2244 will dial the DEFAULT phone number. Time is programmed
in
number of seconds from 00 to 99 (1sec increments) when using the cVideo/Westec interface or 00 to 99 (4sec
increments for a total of 396 seconds) with the Honeywell RapidEye interface.
Example: To program an 20 second wait with the cVideo/Westec interface, enter
20
.
Example: To program an 20 second wait with the RapidEye interface, enter
05
.
Note: The leading 0 must be entered for numbers less than 10.