Eagle Alarm Verification Products 2244 Installation instructions manual - page 11
11
______________________________________________________________________
Option 6: Momentary or Continuous Trip Input
This option determines whether or not the “Emergency Phone” Trip input will cause the 2244 to latch with a
momentary input such as the EMERGENCY button on a hands free “Emergency Phone” or require that the input
remain active until the central station operator comes on line as with a standard hand set type “Emergency Phone”
with a separate trip switch.
1 = Continuous
2 = Momentary
DEFAULT
=
1
______________________________________________________________________
Option 7: Emergency Phone or Trip Input
This option determines whether or not the Trip input will be used with an “Emergency Phone” causing the 2244 to dial
out or will be used with a “Control/Communicator” causing the 2244 to activate in the conventional audio modes.
1 =
Emergency
Phone
2 =
Control/Communicator
DEFAULT =
1
______________________________________________________________________
Option 8: Serial Interface
This option determines what type of DVR interface the 2244 will use. Entering a
2
will select the standard RS232
serial interface as used by cVideo & WESTEC DVR’s. Entering a
1
will select the RapidEye limited serial interface.
1 = Honeywell RapidEye interface
2 = cVideo or Westec (Requires Model 2044/RS232 Serial interface)
Standard DEFAULT =
1
Honeywell RapidEye video Default
Westec DEFAULT: =
2
Cvideo or Westec video Default
______________________________________________________________________
Option 9: Immediate (Link) or Five Minute One Ring Call Back Mode
If Option 7 (above) is selected as a
2
, “Control/Communicator”, then this option determines whether or not the Trip
input will cause the 2244 to activate in the Immediate (Link) mode or in the One Ring Call Back mode.
1 =
Immediate
2
=
One Ring Call Back (for 5 minutes)
DEFAULT =
1
______________________________________________________________________
Option 10: 20 Digit Telephone Number
This is the telephone number (up to 20 digits) that the 2244 will dial when the trip input is activated and the 2244 is
used in a stand-alone mode or when the Rapideye or Sensormatic video equipment is connected but fails to send a
phone number in the programmed time period.
Enter up to 20 digits. If less than 20 digits are used, a
#
must be entered after the last digit, the # indicates end of
the phone number
to the 2244 and causes it to exit the program mode and generate the program progress tone.
Standard DEFAULT: 1-555-555-5555
Westec DEFAULT: (not published)
Note PAUSES: A
*
followed by a number between
1
&
9
can be entered between phone numbers to generate
pauses. The number following the
*
multiplied times 2 equals the pause time in seconds.
Example: to program a phone number with a 2 second pause after the 1
st
number such as 9 (pause) 5551212 enter
the following:
9 *1 5551212#
a 4 second pause would be:
9
*2
5551212#
etc.
______________________________________________________________________
Program Access Code (Dealer Code)
This option allows the dealer/central station to access the module but only to enter the programming modes.
The Program Access code can only be changed using the Access code change mode.
It cannot access the 2-way mode.
Any four digits, 0000 through 9999 (numbers ONLY) may be programmed.
DEFAULT =
1234