Easy@Home EBP-095 User Manual - page 5
7
6
BEFORE YOU START
BEFORE YOU START
The Choice of Power Supply
In order to get the best effect and protect your monitor,please
use the right battery and special power adaptor.
1.
Slide off the battery cover.
2.
Install the batteries by matching
the correct polarity, as shown.
3.
Replace the cover.
1.Battery powered mode:
6VDC 4*AA batteries
2.This unit has an optional AC Power
adaptor which is available as an
accessory.Only use AC adaptor with
below specification (not included).
Installing and Replacing the Batteries
CAUTION
Remove batteries if the device is not likely to be used for some time.
The old batteries are harmful to the environment, so please do not dispose with other
daily trash.
Remove the old batteries from the device and follow your local recycling guidelines.
Do not dispose of batteries in fire. Batteries may explode or leak.
CAUTION
Replace the batteries whenever the below happen
The shows
The display dims
The display does not light up
Setting Date, Time and Measurement Unit
It is important to set the clock before using your blood pressure
monitor, so that a time stamp can be assigned to each record that
is stored in the memory. (year :2011—2050 time format:12 H)
1.When the unit is off,
hold “SET” for 3
seconds to enter the
mode for year setting.
2.Press the “MEM” to
change the [YEAR].
Each press will
increase the numeral
by one in a cycling
manner.
3.When you get the right
year, press “SET” to
confirm, and it will divert
to the [MONTH] setting.
Right picture is the hole in for power adaptor.
Input:100-240VAC 50/60Hz 0.3A Max
Output:6V 1000mA
( Conforms to UL certificate )