Easy@Home EBP-095 User Manual - page 8
13
12
The most recent record (1) is shown first. Each new measurement
is assigned to the first (1) record. All other records are pushed back
one digit (e.g., 2 becomes 3, and so on), and the last record (60) is
dropped from the list.
CAUTION
DATA MANAGEMENT
1.Hold “MEM” for 3
seconds when the
monitor is in the
memory mode ,then
“dEL ALL” will show.
2.Press “MEM” to
confirm deleting and
the monitor will turn
off.
3.If you don’t want to delete the
records, press “START/STOP”
button or “SET” button to
escape.
If you did not get the correct measurement, you can delete all
results for the selected user by the following steps below.
Delete the Records
4. If there is no record.
the right display will
show when recalling
the record.
3. If you want to check another user’s records, press
START/STOP button to turn off the monitor when it is in the
memory recall mode. Then press SET button, the user icon
will be shown, press “SET” button to select the desired user
ID, press “MEM” button to review the selected user’s records.
4. Press the START/STOP button to turn off the monitor.
Otherwise, the monitor will shut off within 1 minute after last
operation.
DATA MANAGEMENT