Easy@Home EBP-095 User Manual - page 6
9
8
BEFORE YOU START
MEASUREMENT
Rest For 5 minutes before
measuring.
Wait at least 3 minutes between
measurements. This allows your
blood circulation to recover.
For a meaningful comparison,
try to measure under similar
conditions. For example, take daily
measurements at approximately
the same time, on the same wrist,
or as directed by a physician.
Tie the Cuff
1.Tie the cuff on your upper arm,
then position the tube off-center
toward the inner side of arm in
line with the little finger.
2.The cuff should be snug but not
too tight. You should be able to
insert one finger between the
cuff and your arm.
3.Sit comfortably with your arm
resting on a flat surface.
2~3cm
4.Patients with Hypertension should
sit with correct posture.
- Bare your arm or wear tights only
when starting measurement.
- Sit comfortably with legs
uncrossed, feet flat on the floor,
back and arm supported.
The center of the cuff should be at
the same level as the right atrium
of the heart.
4.Repeat steps 2 and 3 to
set the [MONTH] and
[DAY].
5.Repeat steps 2 and 3 to
set the [HOUR] and
[MINUTE].
7.After the [MEASUREMENT UNIT] is
set,the LCD will display “dOnE”, and
then turn off.
6.Repeat steps 2 and 3 to set
the [MEASUREMENT
UNIT].
(0.8”~1.2”)