Eberspächer HYDRONIC B 4 W SC Instruction Manual - page 6
6
Introduction
1
Statutory regulations
• Compliance with the statutory regulations and
safety instructions is prerequisite for guarantee
and liability claims.
Failure to comply with the statutory regulations and
safety instructions and incorrect repairs even when
using original spare parts make the guarantee null
and void and preclude any liability for
J. Eberspächer GmbH & Co. KG.
• Subsequent installation of this heater must comply
with these installation instructions.
• The statutory regulations are binding and must also
be observed in countries which do not have any
special regulations.
• Installation of the heater in special vehicles must
comply with the regulations applying to such
vehicles.
• Other installation requirements are contained in the
corresponding sections of this manual.
Safety instructions for installation
and operation
Danger!
Risk of injury, fire and poisoning!
• Disconnect the vehicle battery before starting any
kind of work.
• Before working on the heater, switch the heater off
and let all hot components cool down.
• The heater must not be used in closed rooms, e.g.
in the garage or in a multi-storey car park (do not
leave the engine running when the vehicle is at a
standstill).
Caution!
Safety instructions for installation and operation!
• The heater must only be installed by a JE partner
authorised by the manufacturer according to the
instructions in this manual and possibly according to
special installation recommendations; the same
applies to any repairs to be carried out in the case
or repairs or guarantee claims.
• Repairs by non-authorised third-parties or with not
original spare parts are dangerous and therefore not
allowed. They result in expiry of the type permit of
the heater; consequently, when installed in motor
vehicles they can cause expiry of the vehicle
operating licence.
• The following measures are not allowed:
– Changes to components relevant to the heater.
– Use of third-party components not approved by
J. Eberspächer GmbH & Co. KG.
– Nonconformities in installation or operation from
the statutory regulations, safety instructions or
specifications relevant to safe operation as stated
in the installation instructions and operating
instructions. This applies in particular to the
electrical wiring, fuel supply, combustion air
system and exhaust system.
Please note!