EcoQuest Fresh Air User Manual - page 7
CLEANING THE PURIFIER PLATE:
Remove the rear lint screen (see pages 8 - 9) . Carefully
remove the purifier plate from the card cage by grasping
the middle of the edge nearest to you, and slowly pull it
straight out .
If you are in an environment where there are fats, oils,
or grease, such as in a kitchen, start by cleaning with
denatured alcohol and a soft bristle brush . This will cut
the grease without leaving a residue .
For all applications - Clean with a mixture of one part
water and one part ammonia to remove contaminants .
Place the plate into a shallow dish, and pour enough of
the water/ammonia solution into the dish to just cover
plate . Allow the plate to soak for no more than 10 minutes .
CAUTION: Damage may result from soaking the purifier
plate longer than 10 minutes.
Remove plate and scrub with a soft bristle brush .
Rinse thoroughly . Let air-dry for 24 hours or use a
blow dryer to dry thoroughly .
The unit will display a REPLACE PLATE message if the
purification plate needs to be replaced .
GENERAL MAINTENANCE
(CONT .)
SEE PAGES 8 - 9 FOR REMOvAL AND INSTALLATION INSTRUCTIONS
* See next page for back cover removal instructions
100 & 110 volt models -
use 1 .6
Amp slow blow fuse .
220/240 volt models -
use 1 .0 Amp slow blow fuse .
6
7
To Remove:
Rear Back Panel
follow steps 1 - 3,
pg. 8
Prefilter
follow steps 4 - 5
pg. 8
OPTIONAL PREFILTER
CHANGING THE RCI CELL:
The RCI cell should be changed when REPLACE RCI
CELL appears on the display, or every three (3) years,
whichever comes first . To change the RCI cell, follow the
instructions on pages 8 - 9 .
CHANGING THE FUSE:
The fuse may be accessed by unplugging the cord from
the back of the unit, removing the back cover of the unit
*
,
then pulling, or if necessary, gently prying the fuse out
using a small, straight screwdriver .
2
2. Remove the lint
screen by pulling
back the top,
then lifting up
and out.
1
1. Remove
the two (2)
thumbscrews
securing the
top of the lint
screen.
4
4. Replace
the rear
lint screen,
inserting
the bottom
of the lint
screen first.
5
5. Secure the
top of the
lint screen by
replacing the
two (2) lint
screen holder
thumbscrews.
3
3. (a) For first install,
lay Optional
Prefilter on filter.
(b) For replacing,
remove Optional
Pre-Filter and
replace with a
new one.
Note: The bottom of the rear lint
screen is held into place by two
alignment guides (see inset).
english
spanish