ECX RUCKUS Instruction Manual - page 6

6

EN

RUCKUS

4WD

4WD

Solid Red and Green: 

Battery voltage is 

good (above 4V).

Solid Red: Battery 

voltage is critically low 

(below 4V). Replace 

transmitter batteries.

TRANSMITTER CONTROLS

Battery Level Indicator

Power Switch

Power on or off the transmitter

Reverse Switch

Allows you to change the direction of 

steering (ST) and throttle (TH) controls.

(The default setting for steering and 

throttle is “NOR”)

Throttle Trigger

Controls power

to the motor for

forward or reverse

(See TH reverse 

switch)

Stop

Reverse 

(when TH reverse

switch on NOR)

Forward 

(when TH reverse 

switch on NOR)

Steering Wheel

Control steering. Right 

and Left steering with 

ST switch on NOR 

(See Reverse Switch)

Steering Rate

Adjusts the amount the 

front wheels move when 

the steering wheel is 

turned left or right 

Throttle Dual Rate

Adjusts the maximum 

amount throttle the 

vehicle can be given

Adjusts the neutral 

point of the electronic 

speed control

Throttle Trim

Adjust to make the 

vehicle drive straight 

with no input at the 

steering wheel

Steering Trim

INSTALLING THE VEHICLE BATTERY

1. Turn the battery door latch counter-clockwise to 

release the battery door.

2. Remove the battery door from the vehicle.

3. Connect the battery to the Electronic Speed Control 

(ESC) /Receiver unit connector within the battery 

compartment.

4. Install the vehicle battery pack as shown.

5. Re-install the battery door.

6. Turn the battery door latch clockwise to secure

the door.