ECX RUCKUS Instruction Manual - page 8

8

EN

RUCKUS

4WD

4WD

1. Power off the vehicle. 

4. Disconnect the battery from the ESC/Receiver unit.

3. Remove the battery from the vehicle.

2.  Power off the transmitter.

OFF

WHEN YOU ARE FINISHED

• ALWAYS turn on your transmitter before you turn on the 

receiver in the vehicle. Always turn off the receiver before 

turning your transmitter off.

• ALWAYS operate your vehicle in a wide open area. Operating 

the vehicle in a small space or indoors can cause overheating 

at low speeds. Operating at low speed increases heat in the 

electronic speed control (ESC). Overheating can damage the 

vehicle and failure may result.

Steering Dual Rate

• If the vehicle turns too sharply and/or spins out easily, reduce 

the steering dual rate (turn the knob counterclockwise). 

• For sharper or additional steering, increase the steering dual 

rate (turn the knob clockwise).

Throttle Operation

• Pull the transmitter trigger to increase throttle.

• Push the trigger to apply brake or reverse. 

IMPORTANT: The slower the vehicle is moving, the quicker it 

will change from forward to reverse.

OPERATION