ECX Torment ECX4000 Instruction Manual - Specifications
3
EN
POWER
ST. TRIM
TH. TRIM
ST. RATE
Transmitter
Frequency 2.4GHz
Modulation
DSM, DSM2, Marine
Battery
AA x 4
Servo
Power Supply
4.8V~6V (shared with receiver)
Output Torque
41.66 oz (3 kg-cm)
Operating Speed
0.23sec/60 degrees of travel
Size
40.5 x 20 x 36.8mm
Electronic Speed Control (ESC)
Input Voltage
7.2–8.4V
Electric Capacity (FET)
Forward 80 A/240 A
Electric Capacity (FET)
Reverse 60 A/160 A
PWM Frequency
1kHz
BEC Voltage
5 V/1 A
Size
27 x 35 x 17.3mm
Weight
34–36 g
1. ECX™ Torment™ 1/10-scale Monster Truck
2. Spektrum™ DX2E transmitter
Included Items
3. AA (4)
4. ECX1075 Battery Charger
ECX1075AU Battery Charger (AU)
ECX3013 Battery Charger (EU)
ECX3013 Battery Charger (UK)
5. 7.2V NiMH battery (DYN1050)
2
1
4
3
5
SPECIFICATIONS
COMPONENTS
VEhICLE PREPARATIONS
Charger power outlet
terminals not shown.
INSTALLING TRANSMITTER bATTERIES
1. Slide the panel open on the bottom of the transmitter.
2. Obey the battery plus (+) and minus (-) diagram in the transmitter
to install 4 AA batteries.
3. Slide the panel closed.
We recommend using only alkaline AA batteries in the transmitter,
however, it is possible to use rechargeable NiMH batteries.
CAUTION: If using rechargeable batteries, charge only
rechargeable batteries. Charging non-rechargeable batteries may
cause the batteries to burst, resulting in injury to persons and/or
damage to property.
NEVER install damaged batteries, batteries of mixed types
or batteries of different ages in the transmitter. Remove
exhausted batteries.
NEVER store the transmitter with batteries installed.