ECX Torment ECX4000 Instruction Manual - page 5

5

EN

POWER

ST. TRIM

TH. TRIM

ST. RATE

TRANSMITTER CONTROLS

Battery level IndIcator

Solid Green: Battery voltage  

is good (Above 4V).

Flashing Green: Battery 

voltage is critically low  

(below 4V). Replace batteries.

throttle trIM

Adjusts the neutral point of 

the electronic speed control

steerIng trIM

Adjust to make the vehicle 

drive straight with no input 

at the steering wheel

PoWer sWItch

Power on 

or off the 

transmitter

POWER

ST. TRIM

TH. TRIM

ST. RATE

BIND

TH

ST

N         R

N         R

steerIng Wheel

Control steering. Right and Left 

steering with ST. REV Switch  

on N (See ST. REV switch)

POWER

ST. TRIM

TH. TRIM

ST. RATE

throttle trIgger

Controls power to motor for  forward  

or reverse (See TH. REV switch)

Stop

Reverse  

(when TH.  

REV switch on R)

Forward  

(when TH.  

REV switch on R)

steerIng rate

Adjusts the amount the front  

wheels move when the steering 

wheel is turned left or right 

reverse sWItch

Allows you to change the direction  

of steering  (ST. REV) and throttle (TH. 

REV) controls. (Default settings are  

“N” for steering and “R” for throttle)

BIND

TH

ST

N         R

N         R

The DX2E has a France RF Mode that complies 

with French regulations. The DX2E must be in 

France mode when used outdoors in France.  

At all other times, the transmitter should be  

in Standard mode. 

France mode

Turn the wheel full left, pull the trigger full throttle, 

and hold down the bind button while turning on 

the transmitter. The Green LED will flash twice.

Standard mode  

(deFault preSet Set at Factory)

Turn the wheel full right, pull the trigger full 

throttle, and hold down the bind button while 

turning on the transmitter. The Green LED  

will flash once.

rF Mode