Edelbrock 3670 User Manual - page 17
Manual is about: Edelbrock Electronic Fuel Injection System User Guide
of
235
Installation and Setup
17
AFTER MEASUREMENT:
COMPARING HEIGHT OF STOCK INTAKE ASSEMBLY AND VICTOR PRO TUNER
ASSEMBLY.
1. Remove air cleaner from stock assembly.
2. Lay a straightedge across top of carburetor flange front to rear.
3. Measure from bottom of straightedge to manifold/block sealing surface of manifold
at front and rear of engine. Record measurements (A & B).
4. Add “A” and “B” and divide by 2 to get average height.
5. Measure your Victor assembly using the same method.
6. Compare the measurements. If the Victor dimensions are taller, subtract the
difference from the current hood clearance to determine the new hood clearance.