Edelbrock 3670 User Manual - page 189

Advanced Tuning with the Pro Tuner System

189

5.10

Reset ECU to last programmed setup

Visit us at: http://www.edelbrock.com

Reset to Last Programmed Setup

This feature is accessed via the File Menu from the any of the main screens. It will

reset all the MAP's, values, and wizard choices back to the preset values that the

user started with after the wizard last programmed the ECU. This function can

assist the user to begin the calibration process again if needed. The user can program

the default factory setup by stepping through the setup wizard for the fuel control mode

that you desire (Speed/Density or Alpha-N) and choosing the default or standard

settings.

Resetting to the originally programmed setup using this function will take the settings

and choices back to the ones you last programmed into the ECU when you completed the

setup wizard. Use this feature with the engine NOT RUNNING, but with the ignition ON.

After confirming your selection, turn the ignition switch off for 10 seconds. The values

should then be reset.