FAAC E145 Quick Manual - 2. Installation Sequence
E145
2
732783 - Rev.E
Tr
ansla
tion of the original instruc
tions
ENGLISH
1. TECHNICAL SPECIFICATIONS
CE DECLARATION OF CONFORMITY
The manufacturer
Company name:
FAAC S.p.A. Soc. Unipersonale
Address:
Via Calari, 10 - 40069 Zola Predosa BOLOGNA - ITALY
hereby declares that the following product:
Description:
control board
Model:
E145
conforms to the essential safety requirements of the following ECC directives:
Low Voltage Directive 2014/35/EU
Electromagnetic Compatibility Directive 2014/30/EU
Directive ROHS 2011/65/EU
Furthermore, the following harmonised standards have been applied:
EN 60335-1:2012 + A11:2014 - EN 61000-6-2:2005 - EN 61000-6-3:2007 + A1:2011
Additional note:
this product underwent tests in a typical uniform configuration (all products
manufactured by FAAC S.p.A.).
Bologna, January the 1
st
2016
CEO
INTENDED USE
: this electronic board is designed and
built to control swing and/or sliding gates, which
control access of vehicles and pedestrians.
Thanks to the electronic board E145 and the new
Mains primary power supply With switching power supply from 90 V~ to 260 V~; 50/60 Hz
Power absorbed from mains
stand By
= 4W ;
MAX
~ 800 W ;
sleep
MAX motor load
800 W
Accessories power supply
24 V
"
MAX Accessories current
+24V
"
MAX 500 mA ; BUS-2easy MAX 500 mA ; LOCK (FAAC) 12 V~/ 24 V
"
; LOCK (NON FAAC) 24 V
"
500mA
(3A peak)
Operating temperature
da -20°C to +55°C
Power supply fuses
F1 = F10 AH 250 V
2. INSTALLATION SEQUENCE
Remove the pictures collection from the centre of the instruction manual.
6. Set the electronic board, according to the system
and customer requirements: Chapter 3. Check the
connection of the motors: Paragraph 3.3.
7. Store the remote controls in use on the system:
-
for SLH encoded remote controls: fig.
-
for LC/RC encoded remote controls: fig.
8. Close the doors to perform SET-UP: Chapter 4.
9. According to the installed devices and the regu-
lations in force, set the functions of the board:
Paragraph 3.4.
10. Give an opening impulse to verify that the system
works correctly.
1. Secure the card into the enclosure and fit the pro-
tective cover: fig.
.
2. Wire the electronic board: fig.
-
to connect traditional photocells: fig.
-
to connect and address BUS-2easy photocells:
fig.
-
to connect the receiver module: fig.
-
to connect any Bus encoders: terminal J10, fig.
ref. A.
3. Power the board E145.
4. Verify the status of the LEDs on board: fig.
.
5. Verify the LEDs on any Bus encoders, depending
on the installation: fig.
ref. B.
SAFEcoder
absolute encoder (FAAC Patented), it is easier
to adapt existing systems in accordance with the law
without having to replace the existing automated
systems.