Falcon Classic 110 Dual Fuel User Manual - page 10
10
Oven cooking
The wire shelves should always be pushed fi rmly to
the back of the oven.
Baking trays meat tins etcetera should be placed
level centrally on the oven’s wire shelves. Keep all
trays and containers away from the sides of the
oven, as overbrowning of the food may occur.
For even browning, the maximum recommended
size for a baking tray is 340mm by 340mm.
Cooking high moisture content foods can
create a ‘steam burst’, when the oven door is
opened. When opening the oven stand well
back and allow any steam to disperse.
When the oven is on, don’t leave the door open
for longer than necessary,
otherwise the knobs may get
very hot.
• Always leave a ‘fi ngers
width’ between dishes on
the same shelf. This allows
the heat to circulate freely
around them.
• The Cook & Clean oven
liners (see Cleaning your
cooker) work better when
fat splashes are avoided.
Cover meat when cooking.
• To reduce fat splashing when you add vegetables
to hot fat around a roast, dry them thoroughly or
brush lightly with cooking oil.
• Suffi
cient heat rises out of the oven while
cooking to warm plates in the grill compartment.
• If you want to brown the base of a pastry dish,
preheat a baking tray for 15 minutes before
placing the dish in the centre of the tray.
• Where dishes may boil and spill over during
cooking, place them on a baking tray.
Oven shelves
the shelf guard should be at the back pointing upwards
As well as the fl at shelves some models are
supplied with a drop shelf. The drop shelf increases
the possibilities for oven shelf spacing.
The oven shelves can be easily removed and
refi tted.
Pull the shelf forward until
the back of the shelf is
stopped by the shelf stop
bumps in the oven sides.
Lift up the front of the
shelf so the back of the
shelf will pass under the
shelf stop and then pull
the shelf forward.
To refi t the shelf, line up the shelf with a groove
in the oven side and push the shelf back until the
ends hit the shelf stop. Lift up the front so the shelf
ends clear the shelf stops, and then lower the front
so that the shelf is level and push it fully back.
Australia