Falcon Classic 110 Dual Fuel User Manual - page 17
17
Australia
Troubleshooting
Hotplate ignition or hotplate burners faulty
Is the power on? Is the clock illuminated? If not
there maybe something wrong with the power
supply.
See ‘power supply’ section further on.
Are the sparker (ignition electrode) or burner slots
blocked by debris? Is the burner trim correctly
located? Are the burner caps correctly located?
See the section entitled ‘Cleaning’
Hotplate burners will not light
If only one or all the hotplate burners will not
light, make sure that the parts have been replaced
correctly after wiping or removing for cleaning.
Check that there is not a problem with your gas
supply. You can do this by making sure that other
gas appliances you may have are working.
Do the burners spark when you push the button? If
not check the power is on - is the clock illuminated?
A crack has appeared in the Warmer plate’s surface
Disconnect the cooker immediately from the power
supply and arrange for its repair. Don’t use the
cooker until after the repair. See the HELP leafl et for
how to contact a service person.
Steam is coming from the oven
When cooking foods with a high water content (e.g.
oven chips) there may be some steam visible at the
rear grille. Take care when opening the oven door
as there may be a momentary puff of steam when
the oven door is opened. Stand well back and allow
any steam to disperse.
The oven fan is noisy
The note of the oven fan may change as the oven
heats up - this is perfectly normal.
What cleaning materials are recommended for the
cooker?
See the ‘Cleaning’ section of the Easy Guide for a full
list of recommended cleaning materials. We do not
recommend Mr. Muscle, as it contains chemicals
that may damage the surfaces of your cooker.
The knobs get hot when I use the oven or the grill,
can I avoid this?
Yes, this is caused by heat rising from the oven or
the grill, and heating them up. Don’t leave the oven
door open. Make sure that the grill pan is pushed
right back to the ‘back stop’ when grilling.
The side panels of either oven can be removed.
Each side of the oven is fi xed with four fi xing
screws. You don’t have to remove the screws to
remove the oven linings. Lift each side panel
upwards and they will slide off the screws. Then pull
them forwards.
Once the linings are removed, the oven enamel
interior can be cleaned.
When replacing the linings fi t the side linings fi rst.