Falcon Classic 110 Dual Fuel User Manual - page 36
36
WARNING SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
Conversion to another gas
Conversion from Natural gas (1.0kPa)
to LPG X Propane (2.54kPa)
This conversion must be performed by a competent
person. After conversion the installation must
comply with the relevant regulations and also the
local electricity supply company requirements.
Read the instructions before converting this
appliance.
Failure to convert the appliance correctly could
invalidate any warranty or liability claims and lead
to prosecution.
This instruction must be used in conjunction with the rest
of the appliance instruction, in particular for information on
Standards, cooker positioning, connection hose suitability
etc.
When servicing or replacing gas-carrying components
disconnect from gas before commencing operation and
check appliance is gas sound after completion.
Do not use re-conditioned or unauthorised gas controls.
Jets
Standard burner
Wok burner
A jet, B internal injector, C external injector
Remove burner caps and heads. Remove old jets. Fit new
jets (see Technical Data section at the back of the book for
correct jets). Reassemble in reverse order.
Tap adjustment
Disconnect from electricity supply.
Classic model only
Remove the handrail by removing the 2 end bracket
fi xing screws.
Pull off the push fi t control panel end caps at each end
and remove the end fi xing screws under the end cap.
Open the oven door & or grill door and remove the fi xing
screws underneath the control panel. NB some models have
a plate under the control panel held in place by the bottom
fi xing screws.
Pull off all the control knobs.
Other models
Slide the control panel to the right.
Pull the control panel forward. Take care not to damage or
strain the wiring.
Disconnect leads from back of switches and timer. Lift
control panel clear of cooker.
Remove the tap bypass screw and fi t the correct new one.
See table for correct screws.
Reassemble in reverse order. When replacing leads refer to
the wiring diagram. Check operation of timer.