Falcon Classic 110 gas User Manual - page 25
25
Australia
Fixed Wiring.
For connection to fixed wiring i.e. flexible conduit, remove
the electrical terminal cover box on the back panel. Remove
two screws and blanking plate from the bottom flange of
the cover box, so as to allow the conduit through.
Fix conduit to conduit mounting bracket on the back panel.
Connect mains cable to correct terminals for your electrical
supply type. Check that the links are correctly fitted and the
terminal screws are tight. Replace electric terminal cover
box making sure that the conduit is clear of the bottom
flange.
Current Operated Earth Leakage
Breakers
Where the installation is protected by a 30 milliamp
sensitivity residual current device (RCD), the combined
use of your cooker and other domestic appliances may
occasionally cause nuisance tripping. In these instances the
cooker circuit may need to be protected by fitting 100mA
device. This work should be carried out by a qualified
electrician.
Fitting the plinth
Loosen the 3 screws along the front bottom edge of the
cooker. Hook the central keyhole over the central screw.
Twist and fit each end keyhole over their respective screws.
Tighten the fixing screws.
Oven Light
Press the oven light switch and check that the light is
working.
NB The oven light bulb is not included in the
guarantee
Hobplate
Turn on each plate in turn and check that it heats up.
Grill
Open the grill compartment door. Turn on the grill control
and check that the grill heats up.
Oven check
The clock must be set to the time of day before the ovens
will work.
Press and hold as shown.
At the same time, press - or + until the correct time shows.
Don’t forget it’s a 24 hour clock.
If you make a mistake or press the wrong button, turn off
the power supply for a minute or two and start again.
Turn on the oven and check that the oven fan starts to turn
and that the oven starts to heat up. Turn off the oven.
Customer care
Please complete your details in this Guide, inform the user
how to operate the cooker and hand over the Instructions.
Thank you.