Fantasea F400D User Manual - page 18
18
Inspect and Clean Main O-Ring:
Use a clean wet cloth. Use only water to clean the o-ring's sealing surface.
Do not remove the o-ring unless there is evidence that there is a need to clean
the underside surface, or the channel it sits in.
If the O-ring does need to be removed for cleaning or replacement, use your
two thumbs and at the top corner of the housing where the O-ring groove is,
push up from both side until a corner of the O-ring raises above the groove
and gently grasp this O-ring section and pull it off the housing.
When replacing the O-ring, place it back into the groove starting at the same
corner and gently put it in by pressing it into the groove all around the
housing until it is all sitting in the groove and no part of it is sticking up or
out of the groove. You can then apply a slight layer of silicone if you have
not done this yet. Be sure it is completely seated in the channel for a proper
seal.
Attaching the Zoom Control Guide Ring:
Attach the Zoom Control Guide Ring to the lens. This is attached using the
Velcro strip. Insure that the projected nub is directly on the bottom.
o The Camera and tray are inserted in such a way that the nub
of the Zoom Control Guide Ring is sandwiched between
the two projections found on the lens port. All are pointed a
downward direction. The Zoom Control is operated when
camera is installed in housing is this manner.
Insert 400D Camera and Lens into Housing:
Mount camera with lens on the removable tray, using the tripod screw to
fasten.
o Slide the tray and camera into the housing tray slot. Make
sure it is completely inserted. You will have to raise the
On/Off /Mode Control while inserting tray with camera.
Slide the flash sync cord into the F400 D's hot shoe; gently push to the end.
Align the housing controls with the corresponding buttons on the camera.
Take caution to insure the flat sync cord does not get caught in the housing
seal by storing the slack alongside the left side of the camera.
o Place back cover on the housing and align the both surfaces
of the housing and the o-ring, forming a proper seal.
Position all three latches over latch hooks in ready position.
o Close all three latches at one time. If it is not possible to
close all three latches at the same time, close the bottom
latch first, maintaining pressure on the other side. Then
close the two top latches simultaneously.
Inspect the o-ring seal for proper closure. The o-ring can easily be seen
through the transparent housing.
Take a Test Dive: