Gakken Stirling engine Assemble And Operating Instructions - page 4
A1
stand
A3
body holder
A4
body holder
screw (6mm)
screw (6mm)
screw (6mm)
screw
(6mm)
screw (6mm)
screw (6mm)
A2
body holder
A2
body holder
A1
stand
A9
alcohol holder
screw(6mm) screw(6mm)
screw(6mm)
4
Figure ー
①Put four B4 tires on the
B2 front wheels and the
B3 rear wheels.
②Attach the front wheels
to the B5 front wheel
holder with hexagon
screws (10mm).
③Attach the rear wheels
to the B7 rear wheel shaft
with hexagon screws
(4mm).
4
Assemble the wheels.
One 6mm
large nut
Two 4mm
hexagon screws
※These are for the
rear wheels.
Two 10mm
hexagon screws
※These are for the
front wheels.
One
7mm bush
One
9mm spring
※Check the length of screws
with these diagrams.
Two 6mm
screws
One 18mm
screws
Two 7mm
across washers
One 8mm
across washer
4mm hexagon screws
※These are for the rear wheels.
10mm hexagon screws
※These are for the front wheels.
B1
body
Two
B2
front wheels
Two
B3
rear wheels
Four
B4
tires
B5
front wheel holder
Two
B6
rear wheel holders
B7
rear wheel shaft
①
②front wheels
(with big holes)
③rear wheels
(with small holes)
B4
tire
hexagon screws
(10mm)
hexagon
screws
(4mm)
hexagon
screws
(4mm)
B7
rear wheel shaft
B5
front wheel holder
The width of the
inside projection
is 4mm.
The width of the
inside projection
is 4mm.
The width
of the
outside
projection
is 2.5mm.
The width of the
outside projection
is 2.5mm.
hexagon
screws
(10mm)
The width of the
outside projection
is 2.5mm.
A10
wick holder
A8
alcohol tray
A9
alcohol holder
※Check the difference in the size of the
shaft hole between the front wheels
and the rear wheels.
※Check the size with this.
Full-scale
2
Attaching Wheels to the Body
B
2
Figure ー
Fasten the A2, the
A3 and the A4 body
holders with screws
(6mm).
2
Attach the body holding parts.
3
Figure ー
①Attach the A10
wick holder to the A9
alcohol holder and
set them on the A8
alcohol tray. (Roll the
wick and put it in the
alcohol tray. Do not
fill the fuel alcohol
until just before the
experiment.)
②Fasten the alcohol
lamp to the A1 stand
with screws (6mm).
3
Assemble the alcohol lamp
and attach it to the A1 stand.
①
②
Warning ★ Fire is used for the experiment. Use great caution to avoid
a burn and fire. Do not let a 15 or less-year-old child experiment alone.
※ There may be more screws, washers, nuts
and bushes than actually used for spare.
PARTS
Parts to be used
7
6