Gakken Stirling engine Assemble And Operating Instructions - page 9
25
Figure ー
Assemble F1 safety
cover symmetrically.
(The F2 and the F3
are not the same.)
25
Assemble the safety cover.
Two
F1
safety covers
F5
thermal insulator
F2
hinge part
F3
hinge part
F7
sticker
Four
F4
thermal insulator hooks
Two
F6
32mm pipes
※Check the length of screws
with these diagrams.
Two 6mm
screws
Two 40mm
screws
Two 9mm
across spacer
F4
thermal insulator hook
F4
thermal insulator hook
F1
safety cover
F1
safety cover
screw (6mm)
screw
(6mm)
F3
hinge part
F2
hinge part
screw (6mm)
Strip off the E5 thermal
insulator from the center
into two sheets.
26
Figure ー
Insert the hooks of
the F2 and the F3
hinge parts into the
holes in the sliding
base to attach.
26
Attach the safety covers
to the body.
27
Figure ー
Set the assembled
body on the stand.
27
Set it on the stand.
screw (40mm)
spacer (9mm in diameter)
F6
pipe (32mm)
screw (40mm)
screw (40mm)
F6
pipes (32mm)
screw (40mm)
spacer
(9mm in diameter)
spacer
(9mm in
diameter)
B1
body
the fore part
the hinder part
F1
safety covers
cross section of the
safety cover and the body
B1
F1
F6
pipe
(32mm)
spacer (9mm in diameter)
F2
C3
B1
body
Fit on the fore part
first and then set
the hinder part.
Push down the safety
lever to the left
when setting the body.
A1
stand
the fore
part
the hinder
part
F5
thermal insulators
F1
safety cover
the joint of the body and the stand
※Check the size with this.
Full-scale
6
Attaching the Safety Covers
F
Warning ★ Fire is used for the experiment. Use great caution to avoid
a burn and fire. Do not let a 15 or less-year-old child experiment alone.
※ There may be more screws, washers, nuts
and bushes than actually used for spare.
PARTS
Parts to be used
※Check the size with this.
Full-scale
17
16