Gakken Stirling engine Assemble And Operating Instructions - page 7
14
Figure ー
Attach the control
lever finished at
Figure ー ,to the
body finished at
Figure ー with
6mm screws. Then,
move each lever and
check the operation.
(If there are any
loose levers, tighten
the nut.)
14
12
9
Attach the control lever.
15
Figure ー
Insert the E4 main
piston into the C1
cylinder.
15
Attach the E4 main piston.
16
Figure ー
Put the shaft of the
E7 displacer through
the E3 displacer
holder and then into
the center hole in the
E4 main piston.
16
Attach the E7 displacer.
screw (6mm)
screw (6mm)
B1
body
the fore
part
the hinder
part
D1
control lever
C1
cylinder
E4
main piston
C1
cylinder
E4
main piston
E3
displacer holder
E7
displacer
the fore part
the fore part
the hinder
part
the hinder
part
screw (6mm)
(Pay attention to the
direction of the body.)
※Check the size with this.
Full-scale
17
Figure ー
Attach the E5
connecting rod to the
shaft of the E7
displacer using the
E6 displacer
adjuster.
17
Attach the E5 connecting rod.
18
Figure ー
Fasten the following
parts in this order.
washer (7mm in
diameter)
E5 connecting rod
the connecting rod of
the E4 main piston
nut (small 5mm)
nut (small 5mm)
18
● How to screw two
nuts at once.
Hold the inner nut
with the wrench and
screw the outer nut
with the small nut
wrench.
Attach two connecting rods to the fly wheels.
1
2 3
1
2 3
E7
displacer
E5
connecting rod
E6
displacer adjuster
E6
displacer
adjuster
E5
connecting rod
the connecting rod
of the
E4
main piston
the fore part
the
hinder
part
the hinder
part
nut (small 5mm)
nut (small 5mm)
washer
(7mm in diameter)
washer
(7mm in diameter)
nuts (small 5mm)
1
2
3
wrench
small nut wrench
(The shaft of the displacer is not illustrated to simplify the diagram.)
Fasten at the place where the shaft is coming out about 30mm temporarily.
※Pay attention to the position
of the connecting rods
at the dotted circle.
washer
How to connect the connecting
rods and the fly wheels
the upper
part
the lower
part
E5
E4
E5
E4
washer
nut (small 5mm)
nut (small 5mm)
nut (small 5mm)
nut (small 5mm)
Warning ★ Fire is used for the experiment. Use great caution to avoid
a burn and fire. Do not let a 15 or less-year-old child experiment alone.
12
13