Ganz PIXELPRO SERIES Installation Manual - page 8
PixelPro GXi Series
ZN1-B4NVD43 Installation Guide
03-2014-A
8
Caution
!
4. CAMERA INSTALLATION
4.1. Installing a camera
Caution
!
Sealing gaps is recommended as gaps may appear after the camera installation.
Gaps may cause problems such as moisture, water leakage, and etc., which
negatively affect the operation of the camera if gaps appear but remain
unsealed.
To prevent products from damage, place the camera on a stable and non-
vibrating surface. If the stability is in doubt, consult safety personnel for
reinforcements, and then proceed with the installation.
1)
Place the installation template (outline
shown on the next page) provided in the
package on the desired installation surface.
2) Drill holes in correct positions based on
the template paper, and insert anchor
blocks into the holes.
3) Make sure the necessary cables including
a LAN cable and a power cable are properly
connected to the camera either thru the
ceiling or thru the groove around the
mounting plate.
4) Place the camera body and match three
alignment holes with three anchor blocks
and hold against the mounting surface.
5) Tighten the anchor blocks with screws.
6) Adjust the angle of the camera. Refer to
“4.2. Adjusting the angle of the camera” for
more details.
7) Adjust zoom and focus of the camera.
Refer to “4.3. Adjusting zoom and focus” for
more details.
8) Attach the lens cover on the main body
by rotating it clockwise.