Ganz PIXELPRO SERIES Installation Manual - page 8
PixelPro GXi Series
ZN-DNT372XE-MPD(-1) Installation Guide
03-2014-A
8
4. INSTALLATION
4.1. Installing the camera
Caution
!
Sealing gaps is recommended as gaps may appear after the camera installation.
Gaps may cause problems such as moisture, water leakage, and etc., which
negatively affect the operation of the camera if gaps appear but remain
unsealed.
Caution
!
To prevent products from damage, place the camera on stable and non-vibrating
surfaces. If the stability is in doubt, consult safety personnel for reinforcements,
and then proceed with the installation.
1) Place the installation template (outline
shown on the next page) included in the
package on the desired installation surface.
2) Drill holes in correct positions based on the
template paper, and insert anchor blocks into
the holes.
3) Make sure the necessary cables including a
LAN cable and a power cable are properly
connected to the camera either thru the
ceiling or thru the groove around the
mounting plate.
4) Place the camera body and match three
alignment holes with the corresponding
anchor blocks and hold against the mounting
surface.
5) Tighten the anchor blocks with screws.
6) Adjust the angle/zoom/focus of the camera
Refer to “4.2. Adjusting the angle of the
camera/zoom and focus” for more details.
7)
Place the dome cover on the main body of
the camera. Dome cover has three alignment
holes that match camera body’s alignment
holes.
8) Once properly placed, insert screws into the
three holes of the body and tighten them up.