Ganz ZN-DT1A User Manual - page 28

11.  Network  

11.1  IP Setup  

IP Address Configuration   

The GANZ PixelPro supports both IP version 4 and IP version 6 (IPv6 will be supported as of v3.0). 

Both versions may be enabled simultaneously, and at least one version should be always enabled.   

When using IPv4, the IP address could be set automatically via DHCP, or a static IP address could 

be set manually.    If IPv6 is enabled, your camera receives an IP address according to the   

configuration within the network router.   

There are also options for setting up notification of changes in the IP address, and for using a   

Dynamic Domain Name Service (DDNS). 

NOTE:  IP address assignment via DHCP may lead to the situation where the IP address changes 

and you lose contact with the camera. If your DHCP server can update a DNS server, you can access 

the GANZ PixelPro by a static host name, regardless of having a dynamic IP address. Configure the 

options for notification of IP address change (under Services) to receive notification from the camera 

when the IP address changes.   

DNS Configuration   

    DNS (Domain Name Server) provides the translation of host names to IP addresses on   

your network.   

Primary DNS server   

Enter the IP address of the Primary DNS server for your network.   

Secondary DNS server   

    Enter the IP of the Secondary DNS, which is used if the Primary DNS server is unavailable.