Ganz ZN-DT1A User Manual - page 8

2.3  Adjusting the Camera Direction 

The camera body is set in a 3-axis gimbal mount, allowing movement in the pan, tilt and 

rotational planes. Adjust the direction of the lens so that it faces the subject. 

2.4    Adjusting the Image and Focus   

To adjust the position of the lens:   

ZN-DT1A (Normal Lens) 

  1. Open the Live View page in your web browser. 

        - Select the Setup tab, and open the Installation page.   

        - Set ‘Installation Mode’ to ‘ON’ and select the ‘Video Format' (NTSC). 

    2. Connect analog monitor to the VIDEO OUT (BNC) on the cable. 

        - Unscrew the zoom puller on the lens by turning it counter-clockwise.   

        - Adjust the zoom setting and re-tighten the zoom puller.   

        - Unscrew the focus puller on the lens to adjust the focus, and re-tighten the focus puller.   

    3. Check the image from the Live View page on your web browser. 

    - Set ‘Installation Mode’ to ‘OFF’ to resume normal camera operation.   

NOTE:  DC Auto-Iris should always be disabled while focusing the camera. This will set the iris to 

the wide open position, which yields the smallest depth of field, and thus the best conditions for 

focusing the lens. When the focus has been set by using this method, it will maintain its focus in 

any kind of lighting conditions.