Ganz ZR-DHC1630NP Instruction Manual - 1.3 Basic Connection
Other manuals for ZR-DHC1630NP:
Gms Manual
of
123
15
15
1.3 Basic connection
1.3 Basic connection
Connecting the power cable to the power supply.
1
2
3
4
5
Connect the mouse to the upper PS/2 terminal .
Connect the keyboard to the lower PS/2 terminal.
Connect the VGA monitor to the VGA input on the VGA card.
Connect the camera signal to the BNC terminals (coaxial type).
Connect the Printer to the LPT1 terminal.
[Warning]
• The power cable should be plugged in after all devices are connected. The system will
automatically boot once the power cable is plugged in. The front on/off switch is used
when you reboot the system manually.
6
The devices and cables should be connected to the back panel as shown above.