Garador Garamatic 10 Instructions For Fitting, Operating And Maintenance - page 38
38
TR10A108 RE / 05.2012
Teaching in hand transmitter buttons
9.1
Follow the operating instructions for the external receiver
▶
to register the hand transmitter button for the desired
function.
Excerpt from the declaration of conformity for
9.2
the receiver
Conformity of the abovementioned product with the
requirements of the directives according to article 3 of the
R & TTE directives 1999/5/EC was verified by compliance
with the following standards:
EN 300 220-3
ō
EN 301 489-1
ō
EN 300 489-3
ō
The original declaration of conformity can be requested from
the manufacturer.
10 Operation
WARNING
Danger of injury during door travel
If people or objects are near the door
while the door is in motion, this can lead
to injuries or damage.
Children are not allowed to play near
▶
the door system.
Make sure that no persons or
▶
objects are in the door's area of
travel.
If the door system has only one
▶
safety feature, only operate the
garage door operator if you are
within sight of the door's area of
travel.
Monitor the door travel until the door
▶
has reached the end-of-travel
position.
Only drive or pass through remote
▶
control door systems if the door is in
the Open end-of-travel position!
Never stay standing under the open
▶
door.
CAUTION
Danger of crushing in the boom
Do not reach into the boom with your fingers during door
travel, as this can cause crushing.
Do not reach into the boom during door travel
▶
CAUTION
Danger of injury from the cord knob
If you hang on the cord knob, you may fall and injure
yourself. The operator could break away and injure persons
or damage objects that are located underneath, or the
operator itself could be destroyed.
Do not hang on the cord knob with your body weight.
▶
CAUTION
Danger of injury due to the hot lamp
Touching the cold light reflector lamp during or immediately
following operation can lead to burns.
Do not touch the cold light reflector lamp if it is
▶
switched on or was recently switched on.
CAUTION
Danger of injury resulting from uncontrolled door
movement in the Close direction if one of the
counterbalance springs breaks and the slide carriage is
released.
If a retrofit set is not installed, uncontrolled door movement
in the Close direction may occur if the slide carriage is
released while a counterbalance spring is broken, the door
is improperly balanced or the door is not completely closed.
The responsible fitter must install a retrofit set on the
▶
slide carriage if the following applies:
The standard DIN EN 13241-1 applies
–
The garage door operator is retrofitted to a
–
Hörmann sectional door without spring safety
device (BR30) by a technical expert.
This set includes a screw that secures the slide carriage
against uncontrolled unlocking as well as a new cord knob
sign with images showing how the set and the slide carriage
should be handled for the two operation modes of the
operator boom.
NOTE:
The use of an emergency release or an emergency release
lock is not possible in conjunction with the retrofit set.
ATTENTION
Damage due to the cord of the mechanical release
If the cord of the mechanical release becomes caught on a
roof carrier system or other parts of the vehicle or door, this
can lead to damage.
Make sure that the cable cannot become caught.
▶
Heat generation due to the illumination
As a result of heat being generated by the operator light,
there is a risk of damage if the spacing is inadequate.
The smallest distance to easily inflammable materials or
▶
heat-sensitive surfaces must be at least 0.1 m
(see Figure 7).
Instructing users
10.1
All persons using the door system must be shown how to
▶
operate the garage door operator properly and safely.
Demonstrate and test the mechanical release as well as
▶
the safety reversal.
ENGLISH
www.thegaragedoorcentre.co.uk
0800 525 442
www.thegaragedoorcentre.co.uk