Gardena EasyCut Li-18/23 R Operating Instructions Manual - 4. Initial Operation
ß
A1
ß
A2
q
8. Place the protective cover
q
on top of the trimmer head
3
.
9. Turn the protective cover
q
until it can be pushed over the
trimmer head entirely (the two arrows
ß
A1
,
ß
A2
are directly across
from each other).
10. Rotate the protective cover
q
anti-clockwise until it audibly
engages.
4. Initial Operation
Charging the battery:
6
5
4
8
7
5
9
WARNING!
Overvoltage damages batteries and the battery
charger.
vEnsure the correct mains voltage.
Before using for the first time, the battery must be fully charged.
Charging time (for uncharged battery) see 10. Technical Data.
The lithium-ion battery can be charged in any state of charge,
and the charging process can be interrupted at any time without
harming the battery (no memory effect).
1. Depress both locking buttons
4
and remove the battery
5
from
the battery holder
6
on the handle.
2. Plug the plug of the charger cable
7
into the battery
5
.
3. Plug battery charger
8
into a mains socket.
Charging indicator lamp
9
at the charger unit flashes green
once per second: Battery is being charged.
Charging indicator lamp
9
at the charger unit is lit green:
Battery is fully charged.
(For charging time, see 10. Technical Data.)
Battery charging status indicator during charging:
100 % charged L1, L2 and L3 lit.
66 – 99 % charged L1 and L2 lit, L3 flashing.
33 – 65 % charged L1 lit, L2 flashing.
0 – 32 % charged L1 flashing.
Check the charge status regularly while charging.
4. Once completely charged, disconnect the battery
5
from the
battery charger
8
. Disconnect the battery
5
from the battery
charger
8
first, then unplug the battery charger
8
.
5. Slide the battery
5
onto the battery holder
6
on the handle until
it audibly engages.
16
GB