Gardena EasyCut Li-18/23 R Operating Instructions Manual - page 7
z
Working position 1:
For standard trimming.
Working position 2:
1. Press the foot pedal
z
and lower the shaft downwards into the
desired working position.
2. Release the foot pedal
z
and allow the shaft to engage.
CAUTION! Avoid contact between the ground and the trimmer
head in working position 1 + 2.
Setting the trimmer to body
height:
o
1
h
t
Setting the shaft length:
v Loosen the clamping sleeve
t
, extend the handle
1
to the
desired shaft length and re-tighten the threaded collar
t
.
The clamping sleeve
t
must be fastened firmly enough to
prevent the shaft from being moved.
Setting the additional handle:
v Pull the lock
o
belonging to the additional handle
h
,
set the additional handle
h
to the desired incline and
release the lock
o
.
If the trimmer is correctly set to the body height, the posture
is upright and the trimmer head in
working position 1 is tilted
forwards slightly.
v Hold the trimmer by the handle
1
and additional handle
h
in
such a manner that the trimmer head is tilted forwards slightly.
Adjusting the plant guard:
ö
ö
Working position
Parking position
v Turn plant guard
ö
through 90° into the required position
until it locks into place.
Starting the trimmer:
a
p
Switching the trimmer on:
1. Press and hold the safety lock
p
and then press the start
button
a
on the handle.
2. Release the safety lock
p
again.
Switching the trimmer off:
v Release the start button
a
on the handle.
18
GB