Gardena EasyCut Li-18/23 R Operating Instructions Manual - 8. Troubleshooting
Cleaning the trimmer:
s
s
q
The ventilation slots must always be free of dirt.
v Clean all moving parts after each use, and especially remove
any grass and dirt from the cover
q
and ventilation slots
s
.
Replacing the filament
cassette:
e
W
X
U
W
Y
Risk of injury!
vNever use metallic cutting elements or replacement
parts and accessories not provided by GARDENA.
Only use original GARDENA Filament Cassettes. You can
order Replacement Filament Cassettes from your GARDENA
dealer or directly from the GARDENA Customer Service.
• Filament Cassette for GARDENA Turbotrimmer
Art. 5306
1. Remove the battery.
2. Release the cassette cover
e
by pressing both locking clips
W
and remove the cover.
3. Remove the filament cassette
Y
.
4. Remove any dirt.
5. Feed the cutting filament
U
of the new filament cassette
Y
through the hole
X
and pull out about 10 cm.
6. Insert the filament cassette
Y
.
Do not trap the cutting filament
U
when you do this.
7. Fit the cassette cover
e
so that you hear both locking clips
W
click into place.
v If the cassette cover
e
cannot be touched down, turn the
filament cassette
Y
to and fro, until the filament cassette
Y
is completely in the filament cassette holder.
8. Troubleshooting
Risk of injury!
Risk of injury from the cutting filament!
vRemove the battery immediately in the event of faults!
Pulling the cutting filament
manually out of the filament
cassette:
U
z
37
A cutting filament that is too short or no longer extends
automatically when the trimmer is turned on can be pulled out
manually.
1. Remove the battery.
2. Hold the automatic slide feed
ß
37
down with your hand and
at the same time pull on the cutting filament
U
.
20
GB