Garmin Apollo CNX80 Installation Manaul - page 70
Installation Procedures
2-38
560-0982-01 Rev L
GNS 480 (CNX80) Installation Manual
Label
No.
Parameter
Name
1 2 3 4 6 7 8 9
330 Conic
Arc
Inbound
Course
●
●
331 Conic
Arc
Radius
●
●
332 Airport
Runway
Azimuth
●
●
333 Airport
Runway
Azimuth
●
●
334
Airport Runway Length In Feet
●
●
335
Left/Right Hand Holding Pattern Azimuth
●
●
340
Left/Right Hand Procedure Turn Azimuth
●
●
351G
Distance To Destination (Via Flight Plan)
●
●
●
●
●
352G
Estimated Time To Destination (Via Flight Plan)
●
●
●
●
●
371G
Specific Equipment ID [Note 4]
●
●
●
●
●
●
377
Equipment Hex ID Code [Note 4]
●
●
●
●
●
●
●
●
Notes:
[1] Label 116 is not properly encoded in the GNS 480 Software Version 1.0, 1.1, and 1.2.
Equipment using this label should not be interfaced via ARINC 429 to a GNS 480 with one
of these software versions.
[2] Binary DDM for localizer deviation is limited to ±0.155.
[3] Binary DDM for glideslope deviation is limited to ±0.175.
[4] The GNS 480 Equipment Hex ID is 002 for configurations 1, 2, and 5. For configuration 4,
the Hex ID is 010 when a localizer is tuned, and 011 when a VOR is tuned.
[5] Vertical deviation and scale factor (labels 117G and 327G) were added to the outputs as part
of GNS 480 Software Version 2.0 and do not exist in version 1.3.
Table 2-11.. ARINC 429 Output Labels – Configuration 5 (ARINC 743A)
Label No. Parameter Name
5
076
GNSS Altitude (MSL)
●
101 HDOP
●
102 VDOP
●
103
GNSS Track Angle
●
110 GNSS
Latitude
●
111 GNSS
Longitude
●
112
GNSS Ground Speed
●
120
GNSS Latitude Fine
●
121
GNSS Longitude Fine
●
125
UTC Time Of Day [BCD]
●
130
Horizontal Protection Level
●
133
Vertical Protection Level
●
136
Vertical Figure of Merit
●
140 UTC
Fine
●
141
UTC Fine Fractions
●
150
UTC Time Of Day
●
165
Vertical GPS Velocity
●
166 North/South
Velocity
●
174 East/West
Velocity
●
247
Horizontal Figure of Merit
●
260 Date
[BCD]
●
273
GNSS Sensor Status
●
355
GNSS Fault Summary
●
370
GNSS Height (HAE)
●
377
Equipment Hex ID Code (0Bh)
●
Refer to section 3.2.1.2 for information on configuring the ARINC 429 outputs.