Golden Vantage 1801(A) Installation Instructions Manual

Manual is about: UNDER CABINET-MOUNT RANGE HOOD

Summary of 1801(A)

  • Page 1

    1 30" and 36" under cabinet -mount range hood universal installation instructions and use & care guide for questions about features, operation/performance parts, accessories or service, call: 1-626-453-0550 important: read and save these instructions. For residential use only. Revised september 2014...

  • Page 2: Table Of Contents

    2 table of contents range hood safety ....................................................................3 installation requirements ...................................................4 tools and parts requirements ...................................................4 location requirements ............

  • Page 3: Range Hood Safety

    3 important safety instructions warning: to reduce the risk of fire, electric shock, or injury to persons, read the following: ■ use this unit only in the manner intended by the manufacturer. If you have questions, please contact the manufacturer. ■ before servicing or cleaning the unit, switch the ...

  • Page 4: Installation Requirement

    4 installation requirement tools and parts requirements electrical drill or ratchet driver 1/2” drill bit for drilling pilot holes 1 ¼” drill bit for drilling electrical wiring access hole. Screwdrivers: philips & straight blade pliers tape measure or ruler and pencil electrical supplies for wiring ...

  • Page 5: Installation Dimensions

    5 installation dimensions a. Countertop height b. Hood height from ceiling to bottom of the range hood filter surface: d-a-c=b c. 27” min. From cooking surface, suggested 30” max. D. Ceiling height.

  • Page 6: Ventilation Requirements

    6 ventilation requirements ■ range hoods must be ventilated to the outdoors, except for non-vented (recirculating) installations. ■ do not ventilate the range hood into an attic or other enclosed areas. ■ do not use 4" (10.2 cm) laundry-type wall caps. ■ the length of the range hood and the number o...

  • Page 7: Calculating Vent System

    7 calculating vent system length to calculate the length of the system you need, add the equivalent feet (meters) for all vent pieces used in the system. Electrical reqiurements observe all governing codes and ordinances. Ensure that the electrical installation is adequate and in conformance with th...

  • Page 8: Preparation

    8 preparation advanced preparations: be familiar with the controls of the range hood by reading through range hood controls on page, 12 place the range hood on a flat, stable surface. Connect the range hood to a standard outlet and test out all of controls. Place all supplied parts and required hard...

  • Page 9: Installation

    9 installation installations: measure the distance between the stove top and the bottom of the range hood. A distance of 27” to 30” is recommended. 1. There are two ways (a or b) to mou n t this range hood. 1801a and 1802, type b does not work. A. Proceed if you would like to mount this range hood w...

  • Page 10

    Connect the hooks, gaskets and screws to the unit by screwdriver. Screw the anchor screws to suitable location, then hook on, lock screws. Figure 3 10

  • Page 11: Installation Cont

    11 installation cont inued 4. Connect the range hood to a designated standard outlet or cut off the plug and connect three wires (black, white and green) to house wires and cap with wire connectors. Connect according to colors ( i.E. Black to black, white to white, and green to green. (if applicable...

  • Page 12: Control Operation

    12 control operation control panel layout and buttons configurations: a) lamp: press the lamp display one time to activate the light, press the lamp display again to deactivate it. B) timer: when the range hood is on “standby” mode, press the timer button for 3 seconds. The range hood will then ente...

  • Page 13: Troubleshooting

    13 check if the range hood has been plugged in, make sure that all power has been turned back on, fused not blown and all electrical wiring are properly connected. Swap out light assembly to working ones to determine whether it is caused by a defective bulb. 2. The range hood vibrates when the blowe...

  • Page 14: Use And Care Information

    14 read and understand all instructions and warnings in this manual before operating the appliance. Save these instructions for future reference. Always leave safety grills and filters in place. Without these components. Operating blowers could catch on to hair, fingers and loose clothing. Never dis...

  • Page 15: Maintenance

    15 safety warning: never put your hand into area housing the fan while the fan is operating! For optimal operation, clean range hood and all baffle/spacer/filter/grease tunnel/oil container regularly. Regular care will help preserve the appearance of the range hood. Cleaning exterior surfaces: clean...

  • Page 16

    16 limited warranty for three year from the date of purchase, when this major appliance is operated and maintained according to instructions attached to or furnished with the product, www.Shoprangehoods.Com will pay for factory specified parts. This limited warranty is valid only in the united state...