Golden Vantage 1801(A) Installation Instructions Manual - Installation
9
Installation
Installations:
Measure the distance between the stove top and the bottom of
the range hood. A distance of 27” to 30” is recommended.
1.
There are
two ways (A or B) to mou
n
t this range hood.
1801A and 1802, Type B does not work.
A.
Proceed if you would like to mount this range hood without using the hood-
mounting bracket.
1.
Using references on page
5
, center the hood beneath the cabinet and flush
with the front of the cabinet.
2.
Draw the electrical wires through the cabinet access opening if not done so
already.
3.
From inside of the hood, place screws into the exact center of each
knockout hole and secure to cabinet bottom. Finish tightening all screws
until secure. Be careful when using electrical screwdrivers, they may cause
damage to the range hood. Skip part B below and proceed to step 2.
CAUTION: Make certain the range hood is secure before releasing!
B.
Proceed if you would like to mount this range hood using the provided hood-
mounting bracket
(If included)
.
1.
Using references on page
5
, mark the leveling point of the hood. Position
two mounting screws on the wall, leaving 1/8” space away from the wall.
Mounting the hood on wall studs or lumbar’s is high recommended.
2.
Attach the hood-mounting bracket to the back of the hood with four screws
as show in figure
3
.
3.
Puncture the knockout wire access hole at the back of the hood and draw
the electrical wires.
4.
Align hood-mounting brackets to the screws on the wall and hook hood into
place as shown in
Page 10
. Tighten screws to secure hood to the wall.
CAUTION: Make certain the range hood is secure before releasing!
2. For safety purpose, pre-drilled mounting holes are provided through the back of the hood. For
a more secure installation, use as many mounting holes as needed to secure from the inside of
hood.
3. Use 8
"(size may vary)
venting
pipe (follow building codes in your area) to connect the exhaust
on
the hood to the ductwork above. Use silver tape or duct tape to make all joints secure and air tight.
SAFETY WARNING: Risk of electrical shock. This range hood must be properly grounded. Make
sure this is done by qualified electrician in accordance with all applicable national and local
electrical codes. Before connecting wires, switch power off at service panel and lock service
panel to prevent power from being switched on accidentally.