Golden Vantage 1801(A) Installation Instructions Manual - Installation Requirement
4
INSTALLATION REQUIREMENT
TOOLS AND PARTS
REQUIREMENTS
Electrical drill or ratchet driver
1/2” drill bit for drilling pilot holes
1 ¼” drill bit for drilling electrical wiring access
hole.
Screwdrivers: Philips & Straight blade
Pliers
Tape measure or ruler and pencil
Electrical supplies for wiring
Aluminum foils tape and/or duct tape
Hammer
Jigsaw or saber saw
Stud finder
Parts Supplied
Body
1 Pc
Chimney mounting bracket 2 Pc
Installation manual
1 Set
Metal grease filter 2-3 Pcs
Hardware 1 Set
Disclaimer: Screws many vary from model to
model.
LOCATION REQUIREMENTS
IMPORTANT:
Observe all governing codes
and ordinances. Have a qualified technician
install the range hood. It is the installer’s
responsibility to comply with installation
clearances specified on the model/serial
rating plate.
Canopy hood's location should be away from
strong draft areas, such as windows, doors, and
strong heating vents.
Cabinet opening dimensions that are shown must
be used. Given dimensions provide minimum
clearance.
M5 x 60 QTY:6
8 x 50 Wall anchor QTY:6
Washer QTY:4
M5 x 10 QTY:4