Golden Vantage 1801(A) Installation Instructions Manual - Installation Cont
11
Installation Cont
inued
4. Connect the range hood to a designated standard outlet or cut off the plug and connect three
wires (black, white and green) to house wires and cap with wire connectors. Connect according
to colors ( I.e. black to black, white to white, and green to green. (If applicable)
5. Store excess wires in the wiring box.
6. Drop oil tunnel into recess support near rear of hood. Refer to figure
6
.
7. To install baffle filters, refer to Baffle Filters on page
7
, for baffle filter placement. Refer to
figure
7
for the following five steps:
1.
Angle baffle filter toward back of hood.
2.
Push baffle filter up until almost level.
3.
Slide forward into recess behind the front of the hood.
4.
Lower baffle filter.
5.
Slide back until it fits into resting positions.
8. Repeat step 7 to install all baffle filters.
9. Turn power ON in control Panel. Check all lights and fan operations.
10. Make sure to leave this installation guide for the homeowner.