Golden Vantage 1801(A) Installation Instructions Manual - Maintenance
15
Safety warning: Never put your hand into area housing the fan while the fan is
operating!
For optimal operation, clean range hood and all baffle/spacer/filter/grease tunnel/oil
container regularly. Regular care will help preserve the appearance of the range hood.
Cleaning Exterior surfaces:
Clean periodically with hot soapy water and clean cotton cloth. Do not use
corrosive or abrasive detergent, or steel wool/scoring pads, which will scratch
and damage the stainless steels surface. For heavier soil use liquid degreaser.
If hood looks splotchy, use a stainless steel cleaner to clean the surface of the
hood. Avoid getting clean solution onto or into the control panel. Follow
directions of the stainless steel cleaner.
CAUTION: DO NOT leave on too long,
as this may cause damage to the hoods finish.
Use a soft towel to wipe off the
cleaning solutions. Gently rub off any stubborn spots, Use dry soft towel to dry
the hood.
After cleaning, you may use non abrasive stainless steel polish to polish and buff
out the stainless luster and grain. Always scrub lightly, with clean cotton cloth,
and with the grain.
DO NOT allow deposits to accumulate or remain on the hood.
DO NOT use ordinary steel wool or steel brushes. Small bits of steel may adhere
to the surface and cause rusting.
DO NOT allow salt solutions, disinfectants, bleaches, or cleaning compounds to
remain in contact with water after exposure and wipe dry with a clean cloth.
Replacing Filters:
Should filters wear out due to age and prolonged use, please contact us for
replacement filters.
Note: Also replace damaged filters that has punctured or broken mesh.
Replacing the light bulb:
Make sure the range hood is unplugged or turn OFF the breaker.
Make sure the lights are cool to touch, carefully align the arrow on the inner
ring with the arrow on the outer ring where it says OIPEN. The inner ring will
loosen the light and will be available for removal. To install the new lights,
reverse the steps.
Turn ON the breaker and range hood to test for operation.