Hahnel modus 600rt Instruction Manual - page 13
GB
GB
24
Modus 600RT
Modus 600RT
25
• To reset the Modus 600RT to
factory default settings press
function buttons 3 & 4
at
the same time and hold until
the LCD shows <
RESET
> release the buttons
• When the Modus 600RT is
reset the DCM is also reset
back to open channel and the
previous DCM is lost
Modus 600 RT - Reset
1. Master Unit Setting
• Attach a Modus 600RT to
the camera and set it as the
master unit (Page 22)
• The Viper TTL Transmitter
can also be used as a master
unit to control the wireless
slave Modus 600RT (Page
30)
2. Slave Unit setting
• Set the slave Modus 600RT
to <
SLAVE
> setting
(Page 22)
3. Position of camera and
speedlight
• Position the camera with the
master unit attached and
the Modus slave within radio
range
4. Set the Group
A
flash
mode to
• Check that group <
A
> is
set to
<
MODE
> button until
is displayed
• Check that the slave unit is
set automatically to
by the master unit
5 Check Master/Slave units
are ready
• Check master speedlight,
ready indicator is lighting and
that the slave flash ready
indicators are blinking
TTL Fully Automatic Wireless Flash
Shooting
Basic Automatic Wireless Flash shooting with a
Single Slave Unit
6 Check the Master slave
speedlight operation
• Press the master unit’s < >
test button
• The slave speedlight will
flash. If it does not fire, check
the position or distance of
slave from master
• You are now ready to take a
photo with the wireless flash
lighting
Using Automatic Wireless Flash with
Multiple Slave Units
When stronger flash output or more convenient lighting operation
is needed, increase the number of slave speedlight’s. To add slave
units, use the same steps as setting“automaticwirelessflashwith
a single slave unit”
(Page 25). Any slave speeedlight can be set as
group (A/B/C).
When the number of slave units is increased or the master flash firing
is set to ON, automatic control is performed to fire all flashes at the
correct flash output to ensure that the total flash output results in the
standard exposure.
• If the slave unit’s auto power off takes effect, press the master unit’s
test flash button to turn on the slave unit. Note that the test flash cannot
be performed while the camera’s metering timer, etc. is operating
• The slave units auto power off setting can be changed (C.Fn-Sv / APOT
page 33)
• In the C.Fn settings you can enable a beeper to sound when a Modus
600RT is recharged and ready to fire again
Advanced setting with fully automatic wireless
flash
With the wireless system the following functions set on the master unit
will automatically be adjusted on the slave unit. For this reason you
do not need to operate the slave unit (s) and can operate it from the
master in the same way as normal flash photography.
• Flash Exposure Compensation <
> (Page 16)
• Flash Exposure Bracketing <
FEB
> (Page 17)
• FV Lock: Flash Value Lock (Page 17)
• High-Speed Sync < > (Page 17)
• Manual Flash (Page 17)
• MULTI Flash
(Page 18)