Hahnel modus 600rt Instruction Manual - page 17
GB
GB
32
Modus 600RT
Modus 600RT
33
ZOOM: Setting the Flash Coverage and
Using the Wide Panel
The flash coverage can be set automatically or manually. It can be
set to match the lens focal length from 20 mm to 200mm. Also, with
the built-in wide panel, the flash coverage can be expanded for 14mm
wide-angle lenses.
1. Point the flash head upward
by 90°
2. Pull out the wide panel. The
catchlight panel will come
out at the same time
3. Push the wide panel back in
• Push in only the wide panel
• Follow the same procedures
as for bounce flash
In Manual Zoom mode, press
the
• Turn the Select Dial to
change the flash coverage
• If <
A
> is displayed, the
flash coverage will be set
automatically
Pull out the wide panel and
place it over the flash head as
shown. The flash coverage will
then be extended to 14 mm.
• The catchlight panel will
come out at the same time.
Push the catchlight panel
back in.
• The
will not work.
• If you set the flash coverage manually, make sure it covers the lens focal
length so that the picture will not have a dark periphery.
Using the Wide Panel
C.Fn: Setting Custom Functions
The following table lists the available and unavailable custom functions
of this flash.
1. Software Version
Press
or longer until C.Fn menu is displayed. The “Ver x.x” in the topright
corner refers to the software version.
2. Select the Custom Function No
• Turn the Select Dial to select the Custom Function number
3. Change the Setting
• Press
• Turn the Select Dial to set the desired option. Pressing
button
will confirm the settings.
• After you set the Custom Function and press function button 4, the
camera will be ready to shoot.
4. C.Fn Default
In the C.Fn menu, a long press of the “Clear” button for 2 seconds
until “OK” is displayed on the panel, which means the values in C.Fn
are reset to their default options
Protection Functions
1. Over-Temperature Protection
• To avoid overheating and deteriorating the flash head, do not fire
more than 30 continuous flashes in fast succession at 1/1 full power.
After 30 continuous flashes, allow a rest time of at least 10 minutes
• If you fire more than 30 continuous flashes and then fire more
flashes in short intervals, the inner over-temperature protection
function may be activated and make the recycling time over 10
seconds. If this occurs, allow a rest time of about 10 minutes, and
the flash unit will then return to normal
• When the over-temperature protection is active, < > is shown
on the LCD display