Holman MK21015 Instruction Manual - Maintenance
Misting System Assembly & Installation
Maintenance
5. Maintenance Of Your Misting System
Please use these hints to keep your misting system operational and prevent
unnecessary clogging of the misting jets: -
1)
Drain Water from your System
When your system is not in use, drain all water from your system. If you use an
automatic draining valve, this job will happen automatically.
2)
Clean Nozzles
Periodically clean all nozzles by soaking them in a solution of CLR, or similar
calcium and iron remover.
3)
Flush System
Periodically remove all nozzles and flush the system by running water through
it for 4 or 5 minutes.
4)
Clean Filter
Periodically clean the filter by soaking in a solution of CLR to remove calcium
and iron build up.
6. Troubleshooting
1)
Dis-assemble System
If you need to dis-assemble the system this can be done.
The best way to remove compression fittings from the misting hose is to
“wobble” them from side to side while pulling them apart
If the misting hose is damaged in this action, cut it off before the compressor
fitting is re-installed.
2)
Clean Nozzles
If nozzles are “dripping” or not “misting” properly, they must be removed and
soaked in cleaning solution like CLR. If this fails to clean the jet, it is highly
recommended to purchase replacement jets and replace all jets as require.
9
2014-Misting System Deluxe Instruction Manual V2.indd 11
7/08/2014 4:36:11 PM