Holman MK21015 Instruction Manual - page 8
E. Installing The Misting System
We recommend that each section of pipework is connected together before
you attempt to pin the pipework to walls or beams.
Start at the garden tap or water source point.
If you are using a garden hose to bring water to the area where your misting
system is, it is recommended that you install a sprinkler adaptor into the Misting
Universal tap adaptor. This leaves a male spigot “click on” point where your
standard hose connector will simply click on.
Run the misting tube to the position where you want your first misting jet.
Use Holman Misting Tee or Elbow connectors to go around corners or split
the pipe runs.
Misting System Assembly & Installation
Misting System Assembly & Installation
6
Tap
Auto Drain Valve
Misting Tees
with Nozzles
Misting Elbow End
Misting Tube
Curtain of Mist for most effective coverage.
(Illustration shows 6 Misting Tees and 1
Misting Elbow being used as an example
of a basic layout).
The Misting System - 20M Deluxe Kit allows
for 20 misting nozzles to be used as part
of the set.
Further products to extend your misting
system are available at your local HOLMAN
stockist)
Hose Clamps
Elbow or Tee
Connector
Misting
Tee
Misting
Filter
2014-Misting System Deluxe Instruction Manual V2.indd 8
7/08/2014 4:36:11 PM