Holman MK21015 Instruction Manual - D. Installing The Fittings
D. Installing The Fittings
The Holman Misting System features “compression fittings”.
These fittings feature a compression ring that grips the tube and prevents it
coming loose or leaking water.
The higher the pressure the better the compression fittings hold onto the tube.
To ensure a good joint, the tube must be cut “square” and “burr free”.
The best way to achieve this result is to use the Holman misting tube cutter.
This ensures a clean square cut. It is also very quick to use.
(Holman Misting Tube Cutter sold separately - Product Code: MS20011)
Once the tube is cut the compression fitting is very simply installed.
• Bring the 2 parts together, level and straight.
• Push the tube in while twisting the fitting a little.
• The tube should enter the fitting at least 10mm or until it hits the stop point.
5
Misting System Assembly & Installation
Misting System Assembly & Installation
(Fig. 8)
(Misting Jet)
Tube pushed 10mm
into each fitting
(Fig. 7)
(Misting Jet)
(Misting Jet)
(Misting Tube)
2014-Misting System Deluxe Instruction Manual V2.indd 7
7/08/2014 4:36:10 PM