I-mate PM10A User Manual - Bonds
Pocket PC Phone User Manual
96
Pocket PC Phone User Manual
97
NOTE:
In a situation where Bluetooth is on but radio is off, it is not possible to turn on
radio. If you wish to turn on radio, turn off Bluetooth first, and then turn on radio.
To make your device discoverable
Check
Make this device discoverable to other devices option.
The Bluetooth radio is turned on, and all of the other Bluetooth devices within range (about
10 metres) can detect your device and attempt to beam information to it, establish a bond,
or use a Bluetooth service. In this mode, other devices can detect your device whether or
not a bond has been created; however, in order to receive a beam from another device,
you must accept it on your device.
Other Bluetooth devices can now detect your device and attempt to beam information to
it, establish a bond, or use a Bluetooth service. Note that to receive beamed information,
you must accept it on your device.
Selecting
Discoverable also turns on your Bluetooth radio.
If you no longer want your device to be discoverable, uncheck
Turn on Bluetooth option
or
Make this device discoverable to other devices option to leave the radio on, but not
allow detection by other devices.
Bonds
A
bond is a relationship that you create between your Pocket PC Phone and another
Bluetooth device in order to exchange information in a secure manner. Creating a bond
involves entering the same personal identification number (PIN) on the two devices you
want to bond. You need only create a bond once between two devices. Once a bond is
created, the devices recognize the bond and are able to exchange information without
your entering a PIN again.