I-SENS CareSens N Pop Manual - page 12
24 www.i-sens.com
www.i-sens.com 25
Preparing the Lancing Device
Step 1
Wash hands and sample site with
soap and warm water. Rinse and dry
thoroughly.
Step 2
Unscrew and remove the
lancing device tip.
Step3
Firmly insert a new lancet into the
lancet holder. Hold the lancet firmly.
Gently twist to pull off protective disk.
Save disk to recap lancet after use.
Replace lancing device tip.
Step4
Turn the adjustable tip until it is aligned
with the load confirmation window and
release button as shown in the diagram.
3
4
5
6
7
Caution:
To avoid infection when drawing a sample, do not
use a lancet more than once, and:
• Donotusealancetthathasbeenusedbyothers.
• Alwaysuseanewsterilelancet.
• Keepthelancingdeviceclean.
Note:
Repeated puncturing at the same sample site may
cause pain or skin calluses (thick hard skin). Choose a different
site each time you test.
Using the Lancing Device
You will need a lancing device in order to collect a blood
sample.
You may use CareLance contained in the CareSens N POP Blood
Glucose Monitoring System or any other medically approved
lancing device.
• Thelancingdeviceshouldnotbeusedbymorethanone
individual. Ensure the lancing device is not shared among
different users.
• Useasoftclothortissuetowipethelancingdevice.If
necessary, a small amount of alcohol on a soft cloth or tissue
may be used.
Adjustable Tip
Lancet Holder
Sliding Barrel
Release Button
Load Confirmation
Window
Ejection System
Lancet