I-SENS CareSens N Pop Manual - page 6
12 www.i-sens.com
www.i-sens.com 13
Setting Up Your System
CareSens N POP Blood Glucose Meter Display
Test results :
test results displaying panel
Battery symbol :
indicates meter battery is running low and
needs to be replaced
mem :
appears when test results stored in the memory are
displayed
alarm :
appears when the post-meal alarm has been set
check :
appears when the control solution test results are
saved or displayed
Hypoglycemia symbol :
appears when the test result is below
the hypoglycemic level
Mute symbol :
appears only when the sound is set to OFF
Post-meal test flag :
appears during post-meal testing and
when post-meal test results are displayed
Month / Day / Hour / Minute
Temperature symbol :
displays recorded temperature when
blood glucose levels were tested
Blood insertion symbol :
indicates meter is ready for the
application of a drop of blood or control solution
Decimal point :
appears when the blood glucose measuring
unit is set to mmol/L
10
12
1
2
3
4
5
6
7
8
9
11
Press and hold the
button for 3 seconds to enter the SET
mode. After all settings are finished, press and hold the
button for 3 seconds to turn off the meter.
Press
to reach the correct value. Press and hold
to
scroll faster.
Adjusting the Date and Time
Step 1
Entering the SET Mode
Press and hold the
button for 3
seconds to enter the SET mode. After all
the segments flash across the screen, the
"SET" will be displayed on the screen.
Press the
button again to progress to
the next step.
Step 2
Setting the Year
Press and release
to adjust until the
correct year appears. After setting the
year, press the
button to confirm
your selection and progress to the next
step.
Note:
It is recommended to check if the display screen on the
meter matches the illustration above every time the meter turns
on. Do not use the meter if the display screen does not exactly
match the illustration as the meter may show incorrect results.
1
12
2
3
4
5
6
7
8
9
10
11