Iberital EXPRESSION PRO Installation And Operation Manual - page 69
IBERITAL
INSTALLATION AND OPERATION MANUAL
Page
69
ENGLISH
Litres
xxxxxx
Showing the number of litres of water consumed to date.
- Press
the
MENU
button and the display will show:
Service
xxxxxx
Showing the number of cycles to date. (Activations for any of the dose selections.)
- Press
the
MENU
button and the display will show:
Coffees total
xxxxxx
Showing the total number of coffees dispensed to date.
IMPORTANT
: In order to erase the total number of coffees and reset the counter to zero for the total number of
coffees, press the ‘2 coffees’ and ‘2 espressos’ buttons on GROUP 1 (on the left).
The display will then show:
Coffees total
Total reset
NOTE:
Erasing the total coffee count does not erase the reading for the litres of water consumed. To eliminate
the alarm for CHANGE/REPLACE FILTER for the litres of water consumed, see the section WATER FILTER
CHANGE/REPLACEMENT ALARM.
- Press
the
MENU
button and the display will show:
zzzzz GR:
xxxxxx
Showing the number of coffees by dose and by group.
Continuing to press the
MENU
button will show the number of coffees by selection.
NOTE:
The individual counter for coffee dose type (1 espresso, 1 coffee, etc.) cannot be erased.
2.9.3.1.2. Technical menu display
Remember that to access the
Technical MENU
, the display must be in the
OFF
position (the display will show the
word OFF). If it is in the
ON
position (the display will show the name entered), in order to access the
OFF
mode,
press the
I/O (ON/OFF) or NON-STOP button on the left button pad
and, while pressing it, also press the
TWO ESPRESSOS button on the left button pad
immediately after (based on the display used).
Once in OFF mode, in order to access the technical menu, you must press the
NON-STOP button on the left
button pad or the MENU button
for around 10-15 seconds (based on the display used) and go into technical level
programming mode.
zzzzz: 1 espresso, 1 coffee, etc.
GR: Group 1/2/3
xxxxx: No. of coffees