Icare ic100 Instruction Manual - page 5
Icare ic100 tonometer manual
ENGLISH
www.icaretonometer.com
5
TURNING THE TONOMETER ON
Place the wrist strap around your wrist and secure it. The wrist strap protects the tonometer from dropping onto the floor accidentally.
To turn the tonometer on press the Select or Measure button. Illustrations of these alternative ways of starting:
LOADING THE PROBE
PROBE BASE LIGHT INDICATION
The tonometer includes a ring shaped probe base light which will inform the status of the device. The probe base light will show the inclination of the device
after the probe has been inserted and activated.
The probe base light will also indicate by blinking red if there is an error in measurement or the deviation of the measurement cycle (a series of six individual
measurements) is too high.
Step 1.
Open the probe tube by
removing the cap and insert the
probe into the probe base as shown
in the image.
Step 2.
After loading the probe the
tonometer will be ready for
measurement when Play-symbol
appears on the display.
Battery compartment cover
INSTALLING OR CHANGING THE BATTERIES
Unscrew the battery compartment locking screw with a screwdriver. Remove the battery compartment cover.
Place the wrist strap into the wrist strap attachment at the end of the tonometer.
Insert a new set of four AA batteries. Insert the batteries accordance with the picture below. Do not use rechargeable batteries.
Replace the battery compartment
cover and secure it by screwing
it in lightly using the screwdriver.
Take care not to use excessive
force when screwing the
cover into place.
Pressing the Select button
Pressing the Measure button
1.
2.
3.
4.